Chrome Nickel Steel Sheathed with 16mm thick Twin Insulated Cover Single Piece
Construction.
500 mm long insulated Metal Braided Flexible Leads Barrel Nut Type clamping
with Terminal Protection Box.
Total Wall thickness : 25 mm.
Also available in two piece construction.
Power Saver Construction
To meet the increasing demand to conserve energy by reducing power consumption, PHP has engineered an Exclusive design with Twin Thermal Insulation which helps increase lower the external sheath temp by 40-50%. The built in insulation (as shown in sketch) which not only helps minimize heat dissipation but also produce a better working atmosphere. For eg ; If the Inside surface temp is approx 280°C then the outer Sheath Temp will be approx 90-120 °C.
1.
Chrome Nickel Steel sheathing.
Chrome Nickel Steel housing with serrated edges provides maximum flexibility for ease of installation.
2.
Thermal insulation
In addition to the Built-In 4mm thick heat saving insulation an extra 12mm thick flexible insulation is affixed on the external sheath to reduce power consumption. Further reduction can be obtained by using "POWER SAVER PLUS"
3.
High Grade Ceramic Insulators
Interlocking Steatite bricks designed for best combination of physical & dielectric strength, good thermal conductivity to heat cylindrical parts, good for sheath temperature upto 650°C. provides flexibility for ease of installation on the barrel.
4.
Ni-chrome Heating coil
Helically wound Nickel-Chrome resistance wire designed for maximum current carrying capacity is strung through specially designed ceramic insulating bricks providing even heat distribution, thus eliminating hot spotting that can cause premature heater failure.
